| Product SKUs |
| SYS-2026TT-DLIBXRF | SuperServer 2026TT-DLIBXRF (Black) |
| Motherboards |
| Motherboards | 2x Super X8DTT-HIBXF+ |
| Processor/Cache |
| CPU Type | Dual 1366-pin LGA Sockets
Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
Intel® Xeon® Processor X5600/E5600/L5600 Series
(Westmere) 40W - 95W
Intel® Xeon® Processor X5500/E5500/L5500 Series
(Nehalem-EP) 38W - 95W |
| QPI | up to 6.4 GT/s |
| System Memory |
| Memory Capacity | 12x 240-pin DIMM sockets
Supports up to 192 GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
Supports up to 48 GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory
Memory Mirroring supported |
| Memory Type | 1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs |
| DIMM Sizes | 1GB, 2GB, 4GB , 8GB , 16GB |
| Memory Voltage | 1.5 V |
| Error Detection | Corrects single-bit errors
Detects double-bit errors (using ECC memory)
Supports Intel® x4 and x8 Single Device Data Correction (SDDC) |
| On-Board Devices |
| Infiniband | Mellanox ConnectX DDR Infiniband 20Gbps Controller |
| Chipset | Intel® 5520 (Tylersburg) chipset
ICH10R + IOH-36D |
| SATA | Intel ICH10R SATA 3.0Gbps Controller
RAID 0, 1, 5, 10 support |
| SAS | LSI 6Gbps SAS 2008 IT Mode BPN-ADP-E16-L |
| IPMI | Support for Intelligent Platform Management Interface v.2.0
IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
Winbond® WPCM450 BMC |
| Network Controllers | Dual Intel® 82574L Gigabit Ethernet Controller
Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
Intel® I/OAT 3 support for fast, scaleable, and reliable networking
VMDq support for better performance of virtualization
1x Realtek RTL8201N PHY (dedicated IPMI) |
| Graphics | Matrox G200eW |
| Super I/O | Winbond W83527HG chip |
| Clock Generator | 932S421 chip |
| Input / Output |
| SAS2 | 6x SAS2 ports
6x SAS2 hard drives supported |
| LAN | 2x RJ45 LAN ports
1x RJ45 Dedicated IPMI LAN port |
| USB | 2 rear + 1 header (2 Ports)
4 total USB ports, 2.0 Compliant / 1.1 Compliant |
| VGA | 1x VGA port |
| Serial Ports | 1 Fast UART 16550 serial port |
| Infiniband | 1 External QSFP Infiniband Connector |
| Chassis |
| Form Factor | 2U Rackmount |
| Model | CSE-217HD-R1400B |
| Front Panel |
| Buttons | Power On/Off button
UID button |
| LED | Power LED
Hard drive activity LED
2x Network activity LEDs
System Overheat LED / Fan fail LED /UID LED |
| Expansion Slots |
| PCI-Express | 2 (x8) PCI-E 2.0 (in x16, low-profile) |
| Drive Bays |
| Hot-swap | 12x 2.5" SAS2/SATA Hot-swap drive bays |
| Hard drive Backplane |
| Hard drive Backplane | 2U Hard drive Backplane for 24x 2.5" HDD |
| System Cooling |
| Fans | 4x 8cm 9.5K RPM 4-pin PWM Cooling Fans |
| Power Supply |
| Power Supply | Redundant 1400W high-efficiency power supply with PMBus |
| AC Input | 1200W: 100 - 140V, 50 - 60Hz, 10.5 - 14.7 Amp
1400W: 180 - 240V, 50 - 60Hz, 7.2 - 9.5 Amp |
| DC Output +5V standby | 6 Amp |
| DC Output +12V | 100 Amp @ 100-140V
117 Amp @ 180-240V |
| Certification | 80PLUS |
